Preparing for Engine Start - 4

Well that's the wiring complete and checked, oil pressure and water temperature sensors installed, alternator and starter wired up:

I've also connected the heater hoses but need a hose joiner to make a complete loop as there is no heater installed.

I'm not that happy with the installation of the oil pressure switch and pressure sender as it looks like a bit of bodge! - I'll have to think of a better way for the permanent install:

Next job is to plumb in the oil cooler and fill it together with as much of the pipework as possible. Then the final task will be to connect the fuel lines....... Getting Closer..........