Time to start sorting out bits and pieces in the engine bay. First off was to fit the heater hoses through the inner wing to the heater. I decided that just bending the silicone hose into the correct position wasn't going to look neat enough. So time for some more Aeroquip fittings (I think have developed a fetish for these!). Here's the finished article, nice and neat. I'm going to need a bracket I think under the middle hose separator clamp to stop them sagging when full of water:
The next task was to move the washer bottle as it was going to foul the hard fuel line where it entered the engine bay. The solution was to simply swap the normal positions of the washer bottle and the coil:
0 Comments:
Post a Comment