More Snagging

Some more jobs crossed off the list today:

Fitted the door hinge escutcheons: Adjusted the bonnet and fitted the bonnet rubber:Fixed the hydraulic pressure hoses: Fitted the drivers footwell compartment drain - Here's how its done after forgetting to take photos last time. Take your 10mm 90 deg fitting and file down one end - make cuts in the other end and open out to form a flange - snip off the bottom tabs so it will lie flush with the floor: Mark out the level of the floor and drill a hole:Spread some sikaflex on the tabs and push into place - adding some more on the back when in position:Seal round the front with some more sikaflex:All that remains now is to paint over it with some of the liquid rubber underseal once the sikaflex has gone off.

And finally I fitted the seat runners to the other seat:Nearly there: